Removal and Installation: Installation
- Install rear oil seal.
- Install rear oil seal so that each seal lip is oriented as shown in the figure, below.
A
: Oil seal lip
B
: Dust seal lip
: Engine inside
: Engine outside
- Press in rear oil seal (1) to the position as shown in the figure, below.
|
B |
: Rear oil seal retainer rear end face |
|
a |
: 0 - 0.5 mm (0 - 0.020 in) |
- Using a suitable drift [outer diameter 101 mm (3.98 in)], press-fit until the height of rear oil seal is level with the mounting surface.
- Check the garter spring is in position and seal lips are not inverted.CAUTION:
- Be careful not to damage crankshaft and cylinder block.
- Press-fit straight and avoid causing burrs or tilting oil seal.
- Install in the reverse order of removal after this step.