LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2018 >> Q70 5.6 Luxe, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (5.6L) (Except Hybrid) >> Removal And Installation >> Oil Seal >> Front Oil Seal >> Removal and Installation >> Installation

Removal and Installation: Installation

  1. Install front oil seal on front cover.
    GNSJPBIA0054Z-054Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Engine inside

    SYMBOL

    : Engine outside
    • Apply new engine oil to both oil seal lip (A) and dust seal lip (B).
    • Install it so that each seal lip is oriented as shown in the figure, above.
      CAUTION: Be careful not to scratch or make burrs on circumference of oil seal.
    • Using a suitable drift [outer diameter: 56 mm (2.20 in)], press-fit oil seal until it becomes flush with front cover end face.
    • Check the garter spring is in position and seal lips are not inverted.
  2. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals