LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2018 >> Q70 5.6 Luxe, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (5.6L) (Except Hybrid) >> Removal And Installation >> Oil Pan (Lower) And Oil Strainer >> AWD >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: To avoid the danger of being scalded, never drain engine oil when engine is hot.
  1. Remove engine under cover.
  2. Drain engine oil. Refer to Draining .
  3. Remove oil pan (lower) as per the following:
    1. Loosen mounting bolts in reverse order as shown in the figure below, to remove.
      Fig 1: Oil Pan (Lower) Mounting Bolt Tightening Sequence
      GNSJPBIA2090Z-090Courtesy of NISSAN NORTH AMERICA, INC.

      SYMBOL

      : Engine front
    2. Insert the seal cutter [SST: KV10111100 (J-37228)] (A) between oil pan (upper) and oil pan (lower).
      GNSJPBIA0276Z-276Courtesy of NISSAN NORTH AMERICA, INC.
      CAUTION:
      • Be careful not to damage the mating surfaces.
      • Never insert a screwdriver. This damages the mating surfaces.
    3. Slide the seal cutter by tapping on the side of tool with a hammer. Remove oil pan (lower).
  4. Remove oil strainer.
scientia non olet · About LEMON Manuals