Configuration (BCM): Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing BCM.

Configuration has three functions as follows. [For details, refer to Work Procedure .]

Function		Description
Read / Write Configuration	Before Replace ECU	Reads the vehicle configuration of current BCM. Saves the read vehicle configuration.
	After Replace ECU	Writes the vehicle configuration with saved data.
Manual Configuration		Writes the vehicle configuration with manual selection.

NOTE: Manual setting item: Items which need selection by vehicle specifications

Automatic setting item: Items which are written in automatically (Setting cannot be changed)

For some models and specifications, the automatic setting item may not be displayed.

CAUTION: When replacing BCM, always perform "Re/programming, Configuration" with CONSULT. Or not doing so, BCM control function does not operate normally.

Complete the procedure of "Read / Write Configuration" in order.
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
Never perform "Read / Write Configuration" except for new BCM.
If you set incorrect "Read / Write Configuration", incidents might occur.