Diagnosis Procedure

1. Turn ignition switch ON.
2. Measure voltage between the following terminals of the combination meter.

   Combination meter			Condition	Voltage (Approx.)
   Connector	Terminals
   	(+)	(-)
   M53	7	6	When enter switch is pressed	0 V
   			Other than the above	5 V
   	8		When select switch is pressed	0 V
   			Other than the above	5 V
   	9		When illumination control switch (+) is pressed	0 V
   			Other than the above	5 V
   	10		When illumination control switch (-) is pressed	0 V
   			Other than the above	5 V
   	11		When trip reset switch is pressed	0 V
   			Other than the above	5 V

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect combination meter connector and meter control switch connector.
3. Check continuity between combination meter harness connector and meter control switch harness connector.

   Terminals				Continuity
   Combination meter		Meter control switch
   Connector	Terminal	Connector	Terminal
   M53	6	M54	2	Existed
   	7		1
   	8		11
   	9		6
   	10		3
   	11		12

4. Check continuity between combination meter harness connector and ground.

   Combination meter		Ground	Continuity
   Connector	Terminal
   M53	6		Not existed
   	7
   	8
   	9
   	10
   	11

Is the inspection result normal?

YES

INSPECTION END

NO

Repair harness or connector.