Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect rear sunshade control unit connector.
3. Turn ignition switch ON.
4. Shift A/T shift selector to R position.
5. Check voltage between rear sunshade control unit harness connector and ground.

   (+)		(-)	Condition		Voltage (V) (Approx.)
   Rear sunshade control unit
   Connector	Terminal
   B82	6	Ground	A/T shift selector	R position	Battery voltage
   				Other than the above	0

Is the inspection result normal?

YES

Replace rear sunshade assembly.

NO

Check back-up lamp circuit. Refer to Wiring Diagram .