Inspection After Installation
- Check a drag of front disc brake. If any drag is found, follow the procedure described below.
- Remove brake pads. Refer to Removal and Installation .
- Press the pistons. Refer to Removal and Installation .
- Install brake pads. Refer to Removal and Installation .
- Depress the brake pedal several times.
- Check a drag of front disc brake again. If any drag is found, disassemble the cylinder body. Refer to Disassembly and Assembly .
- Burnish contact surfaces brake pads and disc rotor after refinishing or replacing brake pads, or if a soft pedal occurs at very low mileage. Refer to Inspection and Adjustment .