Removal and Installation: Removal
CAUTION:
Never removing brake pedal stroke sensor. (With pre-crash seat belt)
- Remove the instrument lower panel LH. Refer to Removal and Installation .
- Disconnect the brake pedal stroke sensor harness connector. (With pre-crash seat belt)
- Disconnect the Stop Lamp Switch harness connector and Brake Switch harness connectors.
- Rotate the Stop Lamp Switch and the Brake Switch counterclockwise to remove.
- Remove the snap pin, and then remove the clevis pin from the clevis of brake booster.
- Remove the BCM. Refer to Removal and Installation .
- Remove the brake pedal assembly.CAUTION: Hold the brake booster and master cylinder so as not to drop out or contact them other parts.
- Perform inspection after removal. Refer to Inspection and Adjustment .