LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2018 >> Q70 5.6 Luxe, RWD >> Repair and Diagnosis >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Roof (Except Hybrid) >> Removal And Installation >> Sunroof Unit Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

CAUTION:
  • Always work with a helper.
  • Fully close the glass lid assembly, before removal, then never operate sunroof motor assembly after removal.
  • After removing sunroof motor, never attempt to rotate sunroof motor assembly as a single unit.
  • When remove/install sunroof unit, use cloths to protect the seats and trim from damage.
  • After installing the sunroof unit and glass lid, perform the leak test and check that there is no malfunction.
  1. Remove glass lid. Refer to Removal and Installation .
  2. Remove headlining. Refer to Removal and Installation .
  3. Disconnect drain hoses.
  4. Remove assist grip brackets.
  5. Remove sunroof brackets mounting bolts, and then remove sunroof brackets.
  6. Remove nuts from the front end and side rail, and then remove sunroof unit assembly from roof panel.
  7. Remove sunroof unit assembly through the passenger compartment while being careful not to damage the seats and trim.