Component Inspection

1. Turn Ignition Switch OFF.
2. Disconnect power seat Switch (reclining Switch) connector.
3. Check continuity between power seat Switch (reclining Switch) terminals.

   Power seat Switch (Reclining Switch)		Condition		Continuity
   Terminal
   2	13	Reclining Switch (backward)	Operate	Existed
   			Release	Not existed
   	14	Reclining Switch (forward)	Operate	Existed
   			Release	Not existed

Is the inspection result normal?

YES

INSPECTION END

NO

Replace power seat Switch. Refer to Removal and Installation .