Active Test

Test item

Description

BATTERY SAVER

This test is able to check interior room lamp operation

• On: Operate
• Off: Non-operation

OUTSIDE BUZZER

This test is able to check Intelligent Key warning buzzer operation

• On: Operate
• Off: Non-operation

INSIDE BUZZER

This test is able to check warning chime in combination meter operation

• Take Out: Take away warning chime sounds when CONSULT screen is touched
• Key: Key warning chime sounds when CONSULT screen is touched
• Knob: OFF position warning chime sounds when CONSULT screen is touched
• Off: Non-operation

INDICATOR

This test is able to check warning lamp operation

• KEY ON: "KEY" Warning lamp illuminates when CONSULT screen is touched
• KEY IND: "KEY" Warning lamp blinks when CONSULT screen is touched
• Off: Non-operation

INT LAMP

This test is able to check interior room lamp operation

• On: Operate
• Off: Non-operation

LCD

This test is able to check meter display information

• Engine start information displays when "BP N" on CONSULT screen is touched
• Engine start information displays when "BP I" on CONSULT screen is touched
• Key ID warning displays when "ID NG" on CONSULT screen is touched
• Steering lock information displays when "ROTAT" on CONSULT screen is touched
  NOTE: For models without steering lock unit, "ROTAT" is displayed, but cannot be tested.
• P position warning displays when "SFT P" on CONSULT screen is touched
• INSRT: This item is displayed, but cannot be monitored
• BATT: This item is displayed, but cannot be monitored
• Take away through window warning displays when "NO KY" on CONSULT screen is touched
• Take away warning display when "OUTKEY" on CONSULT screen is touched
• OFF position warning display when "LK WN" on CONSULT screen is touched

FLASHER

This test is able to check hazard warning lamp operation

The hazard warning lamps are activated after "LH/RH/Off" on CONSULT screen is touched

P RANGE

This test is able to check AT shift selector power supply

• On: Operate
• Off: Non-operation

ENGINE SW ILLUMI

This test is able to check push-ignition switch illumination operation

Push-ignition switch illumination illuminates when "ON" on CONSULT screen is touched

LOCK INDICATOR

This test is able to check LOCK indicator (push-button ignition switch) operation

• On: Operate
• Off: Non-operation

ACC INDICATOR

This test is able to check ACC indicator (push-button ignition switch) operation

• On: Operate
• Off: Non-operation

IGNITION ON IND

This test is able to check ON indicator (push-button ignition switch) operation

• On: Operate
• Off: Non-operation

HORN

This test is able to check horn operation

• On: Operate
• Off: Non-operation

TRUNK/BACK DOOR

This test is able to check trunk lid open operation

• Open: Operate

INTELLIGENT KEY LINK

This test is able to check Intelligent Key interlock function

• ID No. 1 BCM transmits Intelligent Key ID No. 1 to each control unit
• ID No. 2 BCM transmits Intelligent Key ID No. 2 to each control unit

INTELLIGENT KEY LINK (CAN)

This test is able to check Intelligent Key interlock function

• Off: Non-operation
• ID No. 1 BCM transmits Intelligent Key ID No. 1 to each control unit via CAN communication line
• ID No. 2 BCM transmits Intelligent Key ID No. 2 to each control unit via CAN communication line
• ID No. 3: BCM transmits Intelligent Key ID No. 3 to each control unit via CAN communication line
• ID No. 4 BCM transmits Intelligent Key ID No. 4 to each control unit via CAN communication line
• ID No. 5 This item is displayed, but cannot be used