Diagnosis Procedure

1. Turn Ignition Switch OFF.
2. Disconnect Rear Door Closure Motor Assembly LH connector.
3. Check voltage between Rear Door Closure Motor Assembly LH harness connector and ground.

   (+)		(-)	Condition		Voltage (Approx.)
   Rear Door Closure Motor Assembly LH
   Connector	Terminal
   D63	1	Ground	Rear door LH	Close operation	Battery voltage
   				Other than above	0 V
   	2			Return signal	Battery voltage
   				Other than above	0 V

Is the inspection result normal?

YES

Replace Rear Door Closure Motor Assembly LH.

NO

GO TO 2.

1. Disconnect Rear Door Closure Control Unit LH connector.
2. Check continuity between Rear Door Closure Control Unit LH harness connector and Rear Door Closure Motor Assembly LH harness connector.

   Rear Door Closure Control Unit LH		Rear Door Closure Motor Assembly LH		Continuity
   Connector	Terminal	Connector	Terminal
   D65	3	D63	1	Existed
   	9		2

3. Check continuity between Rear Door Closure Control Unit LH harness connector and ground.

   Rear Door Closure Control Unit LH		Ground	Continuity
   Connector	Terminal
   D65	3		Not existed
   	9

Is the inspection result normal?

YES

Replace Rear Door Closure Control Unit LH. Refer to Removal and Installation .

NO

Repair or replace harness.