Diagnosis Procedure

1. Turn Ignition Switch OFF.
2. Disconnect Rear Door Closure Control Unit connector.
3. Check voltage between Rear Door Closure Control Unit harness connector and ground.

   (+)			(-)	Voltage (Approx.)
   Rear Door Closure Control Unit
   Connector		Terminal
   LH	D65	6	Ground	12 V
   RH	D85

Is the inspection result normal?

YES

GO TO 3.

NO

GO TO 2.

1. Disconnect BCM connector.
2. Check continuity between BCM harness connector and Trunk Lid Opener Request Switch harness connector.

   BCM		Rear Door Closure Control Unit			Continuity
   Connector	Terminal	Connector		Terminal
   M122	69	LH	D65	6	Existed
   		RH	D85

3. Check continuity between BCM harness connector and ground.

   BCM		Ground	Continuity
   Connector	Terminal
   M122	69		Not existed

Is the inspection result normal?

YES

Replace BCM. Refer to Removal and Installation .

NO

Repair or replace harness.

Check continuity between Rear Door Closure Control Unit harness connector and ground.

Is the inspection result normal?

YES

INSPECTION END

NO

Repair or replace harness.