Diagnosis Procedure

1. Turn Ignition Switch OFF.
2. Check that the following fuses are not blown (open).

   Signal name	Fuse No.
   Battery power supply	5(15 A)
   	6 (10 A)

Is the fuse blown (open)?

YES

Replace the blown (open) fuse after repairing the affected circuit.

NO

GO TO 2.

1. Disconnect Trunk Closure Assembly connector.
2. Check voltage between Trunk Closure Assembly harness connector and ground.

   (+)		(-)	Voltage (Approx.)
   Trunk Closure Assembly
   Connector	Terminal
   T14	4	Ground	Battery voltage
   	6

Is the inspection result normal?

YES

GO TO 3.

NO

Repair harness or connector.

Check continuity between Trunk Closure Assembly harness connector and ground.

Is the inspection result normal?

YES

INSPECTION END

NO

Repair harness or connector.