Diagnosis Procedure

1. Turn Ignition Switch OFF.
2. Disconnect Rear Door Lock Assembly LH connector.
3. Check voltage between Rear Door Lock Assembly LH harness connector and ground.

   (+)		(-)	Voltage (Approx.)
   Rear Door Lock Assembly LH
   Connector	Terminal
   D64	3	Ground	5 V

Is the inspection result normal?

YES

GO TO 3.

NO

GO TO 2.

1. Disconnect Rear Door Closure Control Unit LH connector.
2. Check continuity between Rear Door Closure Control Unit LH harness connector and Rear Door Lock Assembly LH harness connector.

   Rear Door Closure Control Unit LH		Rear Door Lock Assembly LH		Continuity
   Connector	Terminal	Connector	Terminal
   D65	8	D64	3	Existed

3. Check continuity between Rear Door Closure Control Unit LH harness connector and ground.

   Rear Door Closure Control Unit LH		Ground	Continuity
   Connector	Terminal
   D65	8		Not existed

Is the inspection result normal?

YES

Replace Rear Door Closure Control Unit LH. Refer to Removal and Installation .

NO

Repair or replace harness.

Check continuity between Rear Door Lock Assembly LH harness connector and ground.

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace harness.

Refer to Component Inspection .

Is the inspection result normal?

YES

GO TO 5.

NO

Replace Rear Door Lock Assembly LH.

Refer to Intermittent Incident .

INSPECTION END