Inspection And Adjustment: Description
Each function is reset to the following condition when the battery terminal is disconnected. (For details, refer to Special Repair Requirement )
|
Function |
Condition |
Procedure |
|
Memory (Seat, steering, mirror) |
Erased |
Perform storing |
|
Entry/exit assist |
ON |
Perform initialization |
|
Set slide amount *1 |
||
|
Intelligent Key interlock |
Erased |
Perform initialization |
|
Perform storing |
||
|
Seat synchronization |
OFF |
-- |
*1 : Default value is 40 mm.
NOTE:
Notice that disconnecting the battery when detected DTC are present will erase the DTC memory.