Diagnosis Procedure

CONSULT ACTIVE TEST

1. Turn ignition switch OFF.
2. Remove all the bulbs of map lamp, foot lamp, front kicking plate lamp, and personal lamp.
3. Turn ignition switch ON.
4. Select "INT LAMP" of BCM (INT LAMP) active test item.
5. With operating the test item, check continuity between BCM harness connector and ground.

Is the inspection result normal?

YES

GO TO 2.

NO

Continuity exists and remains unchanged: GO TO 3.

NO

Continuity does not exist and remains unchanged: Replace BCM. Refer to Removal and Installation .

1. Turn ignition switch OFF.
2. Disconnect BCM connector, map lamp connector, foot lamp connector, front kicking plate lamp connector and personal lamp connector.
3. Check continuity between BCM harness connector and foot lamp harness connector.

   BCM		Foot lamp			Continuity
   Connector	Terminal	Connector		Terminal
   M122	63	Driver side	M186	2	Existed
   		Passenger side	M114

4. Check continuity between BCM harness connector and front kicking plate lamp harness connector.

   BCM		Front kicking plate lamp			Continuity
   Connector	Terminal	Connector		Terminal
   M122	63	Driver side	B601	2	Existed
   		Passenger side	B603

5. Check continuity between BCM harness connector and map lamp harness connector.

   BCM		Map lamp		Continuity
   Connector	Terminal	Connector	Terminal
   M122	63	R15	2	Existed

6. Check continuity between personal lamp harness connector and map lamp harness connector.

   Personal lamp		Map lamp		Continuity
   Connector	Terminal	Connector	Terminal
   R14	3	R15	4	Existed

Is the inspection result normal?

YES

Replace map lamp, personal lamp or foot lamp.

NO

Repair or replace harnesses.

1. Turn ignition switch OFF.
2. Disconnect BCM connector, map lamp connector, foot lamp connector, front kicking plate lamp connector and personal lamp connector.
3. Check continuity between BCM harness connector and ground.

Is the inspection result normal?

YES

Replace BCM. Refer to Removal and Installation .

NO

Repair or replace harnesses.