Removal and Installation: Removal

Courtesy of NISSAN NORTH AMERICA, INC.

Insert a flat-bladed screwdriver (A) between cluster lid C and instrument side panel LH and RH [within 15.0 mm (0.591 in) from lower end of cluster lid C] and disengage clips.

• 2WD models: Refer to Removal and Installation .
• AWD models: Refer to Removal and Installation .

Courtesy of NISSAN NORTH AMERICA, INC.

1. Remove screw (A).
2. Insert a remover tool (B) between instrument side panel LH and console finisher assembly and disengage metal clips on the lateral side.
3. Pull out instrument side LH toward vehicle rear and disengage metal clips in front end.

Courtesy of NISSAN NORTH AMERICA, INC.

1. Remove screw (A).
2. Insert a remover tool (B) between instrument side panel RH and console finisher assembly and disengage metal clips on the lateral side.
3. Pull out instrument side RH toward vehicle rear and disengage metal clips in front end.

Courtesy of NISSAN NORTH AMERICA, INC.

1. Open the cup holder and console lid.
2. Pull upward to release console mask fixing clips and pawls from center console assembly.

1. Put selector lever in "D" position.
2. Remove screws (A).

   Courtesy of NISSAN NORTH AMERICA, INC.

3. Lift up console finisher assembly back side, and then remove console finisher assembly.

   Courtesy of NISSAN NORTH AMERICA, INC.

   CAUTION:

   • Be careful not to damage front end of console finisher assembly.
   • Disengage slowly so that pawls in rear end of console finisher assembly are not damaged.
   • Be careful not to damage preset switch.

   : Pawl

4. Disconnect harness connectors.

1. Close the console lid assembly.

   Courtesy of NISSAN NORTH AMERICA, INC.

2. Insert remover tool (A) between console rear finisher and center console assembly to disengage the metal clips of console rear finisher lower side.
   CAUTION:

   • Hooks of console rear finisher are engaged at upper and lower. Never pull console rear finisher forcefully.
   • Apply protective tape (B) on the part to protect from damage.

   : Metal clip

3. Pull console rear finisher toward vehicle rear and disengage metal clips on center portion and upper portion of console rear finisher.

   Courtesy of NISSAN NORTH AMERICA, INC.

   CAUTION: Hooks of console rear finisher are engaged at upper and lower. Never pull console rear finisher forcefully.

   : Metal clip

4. Hold both sides of console rear finisher and pull it out towards vehicle rear, while disengaging hooks at upper and lower and then bypassing hooks.

   Courtesy of NISSAN NORTH AMERICA, INC.

   CAUTION: Remove hooks slowly so that they are not damaged.
5. Disconnect harness connector of back side and remove console rear finisher.

1. Disconnect inside key antenna (console) harness connector. Refer to Removal and Installation .
2. Disconnect external data input box harness connector. Refer to Removal and Installation .
3. Disconnect console power socket harness connector. Refer to Removal and Installation .
4. Remove center console assembly fixing screws (A).

   Courtesy of NISSAN NORTH AMERICA, INC.

   : Vehicle front

5. Put front seat to frontmost position.
6. Remove center console assembly fixing screws (B).

   Courtesy of NISSAN NORTH AMERICA, INC.

7. Put front seat to rearmost position.
8. Lift up center console assembly back side, and then remove center console assembly.