Diagnosis Procedure
- COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table .
Is the inspection result normal?
YES
GO TO 2.
NO
Repair or replace the malfunctioning part.
- CHECK LOW BEAM REQUEST SIGNAL
With CONSULT
- Turn ignition switch ON.
- Select "HL LO REQ" in "Data Monitor" mode of "IPDM E/R" using CONSULT.
- With operating the lighting switch, check the monitor status.
Monitor item
Condition
Monitor status
HL LO REQ
Lighting switch
2ND
On
OFF
Off
Is the inspection result normal?
YES
Replace IPDM E/R. Refer to Removal and Installation .
NO
Replace BCM. Refer to Removal and Installation .