Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check that the following fuse is not blown (open).

   Unit	Location	Fuse No.	Capacity
   Parking lamp RH	IPDM E/R	#52	10 A
   Parking lamp LH
   Front side marker lamp RH
   Front side marker lamp LH
   Tail lamp RH (Body side)
   Rear side marker lamp RH
   Tail lamp RH (Trunk lid side)
   Tail lamp LH (Trunk lid side)
   License plate lamp RH
   License plate lamp LH
   Tail lamp LH (Body side)		#53
   Rear side marker lamp LH

Is the fuse blown (open)?

YES

Replace the blown fuse after repairing the affected circuit if a fuse is blown (open).

NO

GO TO 2.

With CONSULT

1. Turn ignition switch ON.
2. Select "EXTERNAL LAMPS" in "Active Test" mode of "IPDM E/R" using CONSULT.
3. With operating the test items, check voltage between IPDM E/R harness connector and ground.
   Tail lamp (Body side)
   
   

   +			-	Test item		Voltage
   IPDM E/R
   Connector		Terminal
   RH	E9	102	Ground	EXTERNAL LAMPS	TAIL	9 - 16 V
   					Off	0 - 1 V
   LH	E7	55			TAIL	9 - 16 V
   					Off	0 - 1 V

   Tail Lamp (Trunk Lid Side)
   
   

   +		-	Test item		Voltage
   IPDM E/R
   Connector	Terminal
   E9	102	Ground	EXTERNAL LAMPS	TAIL	9 - 16 V
   				Off	0 - 1 V

Is the inspection result normal?

YES

GO TO 3.

NO

Replace IPDM E/R. Refer to Removal and Installation .

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector and rear combination lamp connector.
3. Check continuity between IPDM E/R harness connector and rear combination lamp harness connector.
   Tail lamp (Body side)
   
   

   IPDM E/R			Rear combination lamp (Body side)		Continuity
   Connector		Terminal	Connector	Terminal
   RH	E9	102	B260	1	Existed
   LH	E7	55	B26

   Tail Lamp (Trunk Lid Side)
   
   

   IPDM E/R			Rear combination lamp (Trunk lid side)		Continuity
   Connector		Terminal	Connector	Terminal
   RH	E9	102	T15	3	Existed
   LH			T16

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace harness.

Check continuity between rear combination lamp harness connector and ground.

Is the inspection result normal?

YES

Replace the corresponding rear combination lamp. Refer to Removal and Installation (body side) or Removal and Installation (trunk lid side).

NO

Repair or replace harness.