Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check that any of the following fuse is blown (open).

   Unit	Location	Fuse No.	Capacity
   AFS control unit	Fuse block (J/B)	3	10 A

Is the fuse blown (open)?

YES

Replace the blown fuse after repairing the affected circuit if a fuse is blown (open).

NO

GO TO 2.

1. Disconnect AFS control unit connector.
2. Turn ignition switch ON.
3. Check voltage between AFS control unit harness connector and ground.

   +		-	Voltage
   AFS control unit
   Connector	Terminal
   E70	12	Ground	9 - 16 V

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness.

1. Turn ignition switch OFF.
2. Check continuity between AFS control unit harness connector and ground.

   AFS control unit		--	Continuity
   Connector	Terminal
   E70	11	Ground	Existed

Is the inspection result normal?

YES

Power supply and ground circuit are normal.

NO

Repair or replace harness.