Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector and license plate lamp connector.
3. Check continuity between IPDM E/R harness connector and license plate lamp harness connector.

   IPDM E/R			License plate lamp		Continuity
   Connector		Terminal	Connector	Terminal
   RH	E9	102	T8	1	Existed
   LH			T9

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace harness.

Check continuity between license plate lamp harness connector and ground.

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness.

Check the applicable license plate lamp bulb.

Is the inspection result normal?

YES

Replace the corresponding license plate lamp. Refer to Removal and Installation .

NO

Replace the corresponding license plate lamp bulb. Refer to Replacement .