Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect front combination lamp connector.
3. Check continuity between front combination lamp harness connector and ground.

   Front combination lamp			--	Continuity
   Connector		Terminal
   RH	E49	3	Ground	Existed
   LH	E48

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace harness.

Install the normal front combination lamp to the applicable headlamp. Check that the headlamp is turned ON. Refer to Work Procedure .

Is the headlamp turned ON?

YES

Replace the corresponding front combination lamp. Refer to Removal and Installation .

NO

LED headlamp is normal.