Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect front combination lamp connector.
3. Turn ignition switch ON.
4. Check voltage between front combination lamp harness connector and ground.

   +			-	Voltage (Approx.)
   Front combination lamp
   Connector		Terminal
   RH	E49	2	Ground	12 V
   LH	E48

Is the inspection result normal?

YES

Replace front combination lamp. Refer to Removal and Installation .

NO

GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect combination meter connector.
3. Check continuity between front combination lamp harness connector and combination meter harness connector.

   Front combination lamp			Combination meter		Continuity
   Connector		Terminal	Connector	Terminal
   RH	E49	2	M53	17	Existed
   LH	E48			18

Is the inspection result normal?

YES

Replace combination meter. Refer to Removal and Installation .

NO

Repair or replace harness.