Additional Service When Removing Battery Negative Terminal: Description
Each function is reset to the following condition when the battery terminal is disconnected. For details, refer to SPECIAL REPAIR REQUIREMENT .
| Function | Condition | Procedure |
|---|---|---|
| Memory (Seat, steering, mirror) | Erased | Perform storing |
| Entry/exit assist | ON | Perform initialization |
| Set slide amount*1 | ||
| Intelligent Key interlock | Erased | Perform initialization |
| Perform storing |
*1 : Default value is 40 mm.
NOTE:
Notice that disconnecting the battery when detected DTC are present will erase the DTC memory.