LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> QX80 Limited >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel >> Removal And Installation >> Center Console Assembly >> Removal And Installation >> Removal

Removal And Installation: Removal

  1. Remove instrument lower cover.
    GNSJMJIA3828ZZ-828Courtesy of NISSAN NORTH AMERICA, INC.
    1. Pull disengaged pawls downward.
    2. Pull back instrument lower cover.
    3. Disconnect harness connectors.
    SANKAKU-H : Pawl
  2. Remove selector lever knob. Refer to REMOVAL AND INSTALLATION .
  3. Remove console finisher assembly.
    GNSJMJIA3832ZZ-832Courtesy of NISSAN NORTH AMERICA, INC.
    1. Put front seat to rearmost position.
    2. Pull console finisher assembly, upward to disengage from center console assembly.
    3. Disconnect harness connectors.
    MARU-H : Clip
    SANKAKU-H : Pawl
  4. Remove instrument center finisher RH.
    1. Pull the instrument center finisher RH lower side, and then disengage the fixing clip.
      GNSJMJIA4494ZZ-494Courtesy of NISSAN NORTH AMERICA, INC.
      MARU-H : Clip
    2. Pull back instrument center finisher RH, and then disengage metal clips.
    3. Disengage instrument center finisher RH fixing pawl from instrument panel assembly.
    GNSJMJIA4495ZZ-495Courtesy of NISSAN NORTH AMERICA, INC.
    SANKAKU-H : Pawl
    SHIKAKU-H : Metal Clip
  5. Remove instrument center finisher LH.
    1. Pull the instrument center finisher LH lower side, and then disengage the fixing clip.
      GNSJMJIA4496ZZ-496Courtesy of NISSAN NORTH AMERICA, INC.
      MARU-H : Clip
    2. Pull back instrument center finisher LH, and then disengage metal clips.
    3. Disengage instrument center finisher LH fixing pawl from instrument panel assembly.
    GNSJMJIA4499ZZ-499Courtesy of NISSAN NORTH AMERICA, INC.
    SANKAKU-H : Pawl
    SHIKAKU-H : Metal Clip
  6. Remove console rear finisher.
    1. Put front seat to frontmost position.
      GNSJMJIA3848ZZ-848Courtesy of NISSAN NORTH AMERICA, INC.
    2. Pull back console rear finisher with remover tool (A).
    3. Disconnect harness connectors and harness clips.
    CAUTION:

    Apply protective tape (B) on the part to protect it from damage.

    SHIKAKU-H : Metal Clip
  7. Remove center console assembly.
    1. Remove center console assembly rear side fixing screws (A).
      G07025498Courtesy of NISSAN NORTH AMERICA, INC.
    2. Put front seat to rearmost position.
    3. Remove center console assembly front fixing screws (B).
      G07025499Courtesy of NISSAN NORTH AMERICA, INC.
    4. Lift up center console assembly back side, and then remove center console assembly.
scientia non olet · About LEMON Manuals