Inspection Procedure
WARNING: This page is about a different car, the 2016 Infiniti QX50. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
- Fully understand the following items well before the road test;
- Precautions: Refer to PRECAUTION FOR LDW/LDP SYSTEM SERVICE .
- System description for LDW: Refer to SYSTEM DESCRIPTION .
- System description for LDP: Refer to SYSTEM DESCRIPTION .
- Normal operating condition: Refer to DESCRIPTION .
- ACTION TEST FOR LDW
- Drive the vehicle.
- Turn warning systems switch ON (warning systems ON indicator is ON).NOTE:
LDP system is OFF.
- Check the LDW operation according to the following table.
Input Output Vehicle speed
[km/h (MPH)]Vehicle condition/ Driver's operation Action warning systems ON indicator Indication on the combination meter Buzzer Less than 60 (40) Close to lane marker No action ON OFF - 70 (45) or more Close to lane marker Warning
- Buzzer sounds
- Warning lamp blinks
ON Short continuous beeps - Close to lane marker
- Turn signal ON (Deviate side)
No action ON OFF -
GO TO STEP 2 .
- CHECK LDP SYSTEM SETTING
- Start the engine.
- Check that the LDP system setting can be enabled/disabled on the navigation screen.
- Turn OFF the ignition switch and wait for 5 seconds or more.
- Check that the previous setting is saved when the engine starts again.
GO TO STEP 3 .
- ACTION TEST FOR LDP
- Enable the setting of the LDP system on the navigation screen.
- Turn dynamic driver assistance switch ON (LDP ON indicator lamp is ON).NOTE:
LDW system is OFF.
- Check the LDP operation according to the following table.
Input Output Vehicle speed
[km/h (MPH)]Vehicle condition/ Driver's operation Action Indication on the combination meter Buzzer Less than 60 (40) Close to lane marker No action - 70 (45) or more Close to lane marker Warning and yawing - Buzzer sounds
- Warning lamp blinks
- Brake control
Short continuous beeps - Close to lane marker
- Turn signal ON (Deviate side)
No action - Close to lane marker with soft braking Warning - Buzzer sounds
- Warning lamp blinks
Short continuous beeps VDC OFF switch:
OFF → ONCancellation - Buzzer sounds
- Indicator lamp blinks
NOTE:When dynamic driver assistance switch is ON → OFF, indicator lamp is turned OFF.
Beep Snow mode switch:
OFF → ON
(If equipped)Cancellation - Buzzer sounds
- Indicator lamp blinks
NOTE:When dynamic driver assistance switch is ON → OFF, indicator lamp is turned OFF.
Beep
WORK END