Diagnosis Procedure

1. Turn ignition switch ON.
2. Check the voltage between combination meter harness connector and ground.

   (+)		(-)	Condition		Voltage (Approx.)
   Combination meter		Ground
   Connector	Terminal
   M34	26		Ignition switch ON	When parking brake is applied	0 V
   				When parking brake is released	12 V

Is the inspection result normal?

YES 

INSPECTION END

NO 

GO TO STEP 2. 

1. Turn ignition switch OFF.
2. Disconnect combination meter connector and parking brake switch connector.
3. Check continuity between combination meter harness connector and parking brake switch harness connector.

   Terminals				Continuity
   Combination meter		Parking brake switch
   Connector	Terminal	Connector	Terminal
   M34	26	M11	1	Existed

4. Check continuity between combination meter harness connector and ground.

   Terminals			Continuity
   Combination meter		Ground
   Connector	Terminal
   M34	26		Not existed

Is the inspection result normal?

YES 

INSPECTION END

NO 

Repair harness or connector.