Diagnosis Procedure
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK POWER AND GROUND CIRCUITS OF ELECTRICALLY-DRIVEN INTELLIGENT BRAKE UNIT
Perform diagnosis of electrically-driven intelligent brake unit power and ground circuits. Refer to DIAGNOSIS PROCEDURE .
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Repair or replace error-detected parts.
- CHECK DATA MONITOR
With CONSULT
- Turn the ignition switch OFF to ON without depressing the brake pedal.CAUTION:
Never set the vehicle to READY/Never start the engine.
- Repeat step 4 two times or more.CAUTION:
Be sure to wait for 5 seconds or more after turning the ignition switch OFF.
- Start CONSULT and select "BCM" and "DATA MONITOR" according this order.
- Check following monitor item. Refer to REFERENCE VALUE
.
- "DOOR STAT - DR"
- "DOOR STAT - AS"
- "DOOR STAT - RR"
- "DOOR STAT - RL"
- "BK DOOR STAT"
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO STEP 3 .
- Turn the ignition switch OFF to ON without depressing the brake pedal.
- PERFORM BCM SELF-DIAGNOSIS
Start CONSULT and perform self-diagnosis for "BCM".
Is DTC detected?
YES
Check the DTC. Refer to DTC INDEX .
NO
GO TO STEP 4 .
- PERFORM ELECTRICALLY-DRIVEN INTELLIGENT BRAKE UNIT SELF-DIAGNOSIS
Start CONSULT and perform self-diagnosis for "BRAKE".
Is DTC "U1000" detected?
YES
Refer to TROUBLE DIAGNOSIS FLOW CHART .
NO
INSPECTION END