DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.

GO TO STEP 2 .

CHECK DTC DETECTION

With CONSULT
1. Turn the ignition switch OFF to ON without depressing the brake pedal.
  CAUTION:
  Never set the vehicle to READY/Never start the engine.
2. Repeat step 1 two times or more.
  CAUTION:
  Be sure to wait for 5 seconds or more after turning the ignition switch OFF.
3. Turn the ignition switch OFF and disconnect CONSULT from data link connector.
4. Get out of the vehicle, close all doors (including trunk lid), check that the map lamp is OFF, and wait for 3 minutes or more without opening these doors.
  CAUTION:
  Never operate the vehicle.
5. Turn the ignition switch ON without depressing the brake pedal.
  CAUTION:
  Never set the vehicle to READY/Never start the engine.
6. Start CONSULT, and erase self-diagnosis result of "BRAKE" after record or print self-diagnosis results and freeze frame data (FFD).
7. Turn the ignition switch OFF and disconnect CONSULT from data link connector.
8. Get out of the vehicle, close all doors (including trunk lid), check that the map lamp is OFF, and wait for 3 minutes or more without opening these doors.
  CAUTION:
  Never operate the vehicle.
9. Turn the ignition switch ON without depressing the brake pedal.
  CAUTION:
  Never set the vehicle to READY/Never start the engine.
10. Depress brake pedal by 100 mm (3.94 in) or more, and hold the position for 5 seconds or more.
11. Release brake pedal.
12. Start CONSULT and perform "BRAKE" self-diagnosis.
Is DTC "U1010" detected?

YES

Proceed to DIAGNOSIS PROCEDURE .

NO-1

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO-2

Confirmation after repair: INSPECTION END