LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> QX70 RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Brake Control System (With VDC) (Diagnostic Trouble Codes (DTCS) C1101-C1111) (Hybrid)) >> DTC/Circuit Diagnosis >> DTC C1110: Abs Actuator And Electric Unit (Control Unit) >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

  1. PRECONDITIONING

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO STEP 2  .

  2. CHECK DTC DETECTION

    G-20 With CONSULT

    1. Turn the ignition switch OFF.
      NOTE:

      Wait at least 10 seconds after turning ignition switch OFF.

    2. Set the vehicle to READY/Start the engine.
      NOTE:

      Wait at least 10 seconds after set the vehicle to READY/start the engine.

    3. Repeat step 1 to 2 two or more times.
    4. Perform self-diagnosis for "ABS".

    Is DTC "C1110" detected?

    YES - 1 

    "CRNT" is displayed: Proceed to DIAGNOSIS PROCEDURE .

    YES - 2 

    "PAST" is displayed: INSPECTION END (Erase the memory of self - diagnosis results.)

    NO - 1 

    To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

    NO - 2 

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals