Work Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

When performing the procedure below, ensure the ignition is ON.
When performing the procedure below, ensure the vehicle is not in ready mode. Performing the actions below with the vehicle in ready mode may cause additional errors.

WRITING MODE SELECTION

CONSULT Configuration
1. Turn ignition switch ON.
  CAUTION:
  Never bring the vehicle into the READY status.
2. Select "Re/programming, Configuration" of Li-ion battery controller (LBC).
When writing saved data

GO TO STEP 2 .

When writing manually

GO TO STEP 3 .

PERFORM "AFTER REPLACE ECU" OF "READ / WRITE CONFIGURATION"

CONSULT Configuration

Perform "After Replace ECU" of "Read / Write Configuration".

GO TO STEP 4 .

PERFORM "MANUAL CONFIGURATION"

CONSULT Configuration
1. Select "Manual Configuration".
2. Touch "Next".
3. Touch "OK".
4. Check that the configuration has been successfully written and touch "End".
GO TO STEP 4 .

CHECK ALL ECU SELF - DIAGNOSIS RESULTS
1. Erase all ECU self - diagnosis results using CONSULT.
2. Turn the ignition switch OFF.
3. Turn ignition switch ON.
  CAUTION:
  Never bring the vehicle into the READY status.
4. Check that no DTC is detected.
WORK END