Diagnosis Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the 12V battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
  - Side radar RH
  - Harness connector T55
  - Harness connector T9
Is the inspection result normal?

YES

GO TO STEP 2 .

NO

Repair the terminal and connector.

CHECK RIGHT/LEFT SWITCHING SIGNAL CIRCUIT

Check the right/left switching signal circuit of the side radar RH. Refer to DIAGNOSIS PROCEDURE .

Is the inspection result normal?

YES

GO TO STEP 3 .

NO

Repair the root cause.

CHECK HARNESS FOR OPEN CIRCUIT

Disconnect the connector of side radar RH.

Check the resistance between the side radar RH harness connector terminals.

Side radar RH harness connector			Resistance (Ω)
Connector No.	Terminal No.
T42	4	3	Approx. 54 - 66

Is the measurement value within the specification?

YES

GO TO STEP 4 .

Replace the tail harness.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the side radar RH. Refer to DIAGNOSIS PROCEDURE .

Is the inspection result normal?

YES (Present error)

Replace the side radar RH. Refer to REMOVAL AND INSTALLATION .

YES (Past error)

Error was detected in the side radar RH branch line.

NO

Repair the power supply and the ground circuit.