Diagnosis Procedure
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CONNECTOR
- Turn the ignition switch OFF.
- Disconnect the battery cable from the negative terminal.
- Disconnect the following harness connectors.
- ECM
- A/C auto amp.
- AFS control unit
- Check the continuity between the A/C auto amp. harness connector and the AFS control unit harness connector.
A/C auto amp. harness connector AFS control unit harness connector Continuity Connector No. Terminal No. Connector No. Terminal No. M88 1 M4 1 Existed 21 13 Existed
Is the inspection result normal?
YES (Present error)
Check CAN system type decision again.
YES (Past error)
Error was detected in the main line between the A/C auto amp. and the AFS control unit.
NO
Repair the main line between the A/C auto amp. and the AFS control unit.