Removal And Installation: Installation

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

Note the following and Install in the reverse order of removal.

WARNING:

To prevent electric shock hazards, be sure to wear protective gear.

Apply the recommended grease* to the full periphery of the transmission assembly shaft spline .
*: Lithium-based grease including molybdenum disulphide.

Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
- Remove any grease that contacts the transmission assembly shaft end .
- Never apply grease to the CSC release bearing surface . Fully remove any grease that contacts the CSC release bearing surface.

Install the fixing bolts of transmission assembly and engine according to the following standards.

Courtesy of NISSAN NORTH AMERICA, INC.

Bolt symbol
Insertion direction	Transmission to engine	Engine to transmission
Number of bolts	8	4
Bolt length "L" mm (in)	65 (2.56)	35 (1.38)
Tightening torque N•m (kg-m, ft-lb)	75 (7.7, 55)	46.6 (4.8, 34)