Disassembly And Assembly: Disassembly
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- Remove armrest. Refer to REMOVAL AND INSTALLATION .
- Remove headrest holder.CAUTION:
Before installing headrest holder check its orientation (front/ rear and right/ left).
Use pincers, etc., to press up pawls as shown by the arrows in the figure, and remove headrest holder from seatback.
- Remove hog rings, and then separate seatback trim and seatback pad.CAUTION:
Before performing separating operation, check the installation position of hog rings.