System Description: Description

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

When exiting, the condition is satisfied, the seat is moved backward 40 mm (1.57 in) from normal sitting position and the steering is moved to the most upper position.
The seat slide amount and the steering operation at entry/exit operation can be changed.

NOTE:

This function is set to ON before delivery (initial setting).
Further information for the system setting procedure. Refer to DESCRIPTION .

OPERATION PROCEDURE

Shift position P position.
Open the driver door with ignition switch in OFF position.
Driver seat and steering column will move to the exiting position.

OPERATION CONDITION

Satisfy all of the following items. The exit assist function is not performed if these items are not satisfied.

Item	Request status
Ignition position	OFF
System setting [Entry/exit assist function (seat/steering) ]	ON
Initialization	Done
Switch inputs Power seat switch Tilt & telescopic switch Door mirror remote control switch Set switch Memory switch	OFF (Not operated)
A/T shift selector	P position
Handle position	LHD
Transmission	A/T
CONSULT	Not connected

DETAIL FLOW

Order	Input	Output	Control unit condition
1	Door switch (Driver side)	-	Driver seat control unit receives door switch signal (driver side/open) from BCM via CAN communication.
2	-	Motors (Sliding, tilt)	Driver seat control unit operates the seat sliding motor, which recognizes that the driver side door is opened with ignition switch OFF. Driver seat control unit then requests the operations of tilt motor to auto drive positioner control unit via UART communication. The automatic drive positioner control unit operates each motor for a constant amount.
3	Sensor (Sliding, tilt)	-	Each sensor monitors the operating positions of seat and steering, and then stops the operation of each motor when steering reaches to the tilt top position and seat reaches to the rear most position.