Diagnosis Procedure

1. Turn Ignition Switch OFF.
2. Check 10 A fuse, [No. 6, located in fuse block (J/B)].

Is the fuse blown (open)?

YES 

Replace the blown (open) fuse after repairing the affected circuit if a fuse is blown (open).

NO 

GO TO STEP 2  .

1. Disconnect Intelligent Key Warning Buzzer connector.
2. Check voltage between Intelligent Key Warning Buzzer harness connector and ground.

   (+)		(-)	Voltage (V) (Approx.)
   Intelligent Key Warning Buzzer
   Connector	Terminal
   E80	1	Ground	Battery voltage

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

Repair or replace harness.

1. Disconnect BCM connector.
2. Check continuity between BCM harness connector and Intelligent Key Warning Buzzer harness connector.

   BCM		Intelligent Key Warning Buzzer		Continuity
   Connector	Terminal	Connector	Terminal
   M121	64	E80	3	Existed

3. Check continuity between BCM harness connector and ground.

   BCM		Ground	Continuity
   Connector	Terminal
   M121	64		Not existed

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

Repair or replace harness.

Check COMPONENT INSPECTION .

Is the inspection result normal?

YES 

Replace BCM. Refer to REMOVAL AND INSTALLATION .

NO 

Replace Intelligent Key Warning Buzzer. Refer to REMOVAL AND INSTALLATION .