DTC Confirmation Procedure
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO STEP 2 .
- DTC REPRODUCTION PROCEDURE
With CONSULT
- Set the vehicle to READY state or start the engine.CAUTION:
Never drive the vehicle.
- Perform self-diagnosis for "EPS/DAST 3".
Is DTC "C13E6 - 00" detected?
YES
Proceed to diagnosis procedure. Refer to DIAGNOSIS PROCEDURE .
NO
The temporary rise of steering force motor internal temperature caused the protection function to operate. This is not a system malfunction. INSPECTION END
- Set the vehicle to READY state or start the engine.