DTC Confirmation Procedure
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO STEP 2 .
- CHECK DATA MONITOR
With CONSULT
- Set the vehicle to READY state or start the engine.CAUTION:
Never drive the vehicle.
- On the CONSULT screen, select "EPS/DAST 3">>»"DATA MONITOR">>"TORQUE SEN MAIN 1".
- Check that the value is within standard value while steering the steering wheel.
Monitor item Standard value (Approx.) TORQUE SEN MAIN 1 - 0.9 N•m ≤ TORQUE SEN MAIN 1 ≤ 0.9 N•m
Is the inspection result normal?
YES
Steering clutch protection function is active temporarily by overloading the steering wheel. This is not system malfunction.
NO
Proceed to diagnosis procedure. Refer to DIAGNOSIS PROCEDURE .
- Set the vehicle to READY state or start the engine.