DTC Confirmation Procedure
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO STEP 2 .
- DTC REPRODUCTION PROCEDURE
With CONSULT
- Set the vehicle to READY state or start the engine.CAUTION:
Never drive the vehicle.
- Turn the steering wheel from full left stop to full right stop.
- Perform self-diagnosis for "EPS/DAST 3".
Is DTC "C13D5 - 00" detected?
YES
Proceed to diagnosis procedure. Refer to DIAGNOSIS PROCEDURE .
NO - 1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO - 2
Confirmation after repair: INSPECTION END
- Set the vehicle to READY state or start the engine.