Diagnosis Procedure
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FUSE
- Turn ignition switch OFF.
- Check that the following fuse is not blown (open).
Power source Fuse No. Capacity Battery #7 15 A Ignition switch ACC #1 10 A Ignition switch ON #12 10 A
Is the fuse blown (open) ?
YES
Replace fuse after repairing the applicable circuit.
NO
GO TO STEP 2 .
- CHECK NAVI CONTROL UNIT BATTERY POWER SUPPLY
- Turn ignition switch OFF.
- Disconnect NAVI control unit harness connector.
- Check the voltage between NAVI control unit harness connector and ground.
(+) (-) Voltage
(Approx.)NAVI control unit Connector Terminal M60 1 Ground Battery voltage 15
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Perform trouble diagnosis for battery power supply circuit.
- CHECK NAVI CONTROL UNIT ACCESSORY POWER SUPPLY
- Turn ignition switch ON.
- Check the voltage between NAVI control unit harness connector and ground.
(+) (-) Voltage
(Approx.)NAVI control unit Connector Terminal M60 5 Ground Battery voltage
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Perform trouble diagnosis for accessory power supply circuit.
- CHECK NAVI CONTROL UNIT IGNITION POWER SUPPLY
Check the voltage between NAVI control unit harness connector and ground.
(+) (-) Voltage
(Approx.)NAVI control unit Connector Terminal M60 19 Ground Battery voltage Is the inspection result normal?
YES
GO TO STEP 5 .
NO
Perform trouble diagnosis of ignition power supply circuit.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Check the continuity between NAVI control unit and ground.
(+) (-) Continuity NAVI control unit Connector Terminal M60 3 Ground Existed 17
Is the inspection result normal?
YES
INSPECTION END
NO
Repair or replace malfunctioning parts.