LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> QX70 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Audio, Visual & Navigation System (INFINITI INTOUCH) (Diagnostic Trouble Codes (DTCS) B1F10-U1725 And Circuit Diagnosis) (Hybrid)) >> DTC / Circuit Diagnosis >> DTC U1232: Steering Angle Sensor >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

  1. ADJUST THE PREDICTIVE COURSE LINE CENTER POSITION OF THE STEERING ANGLE SENSOR

    Adjusts the steering angle sensor neutral position on ABS actuator and electrical unit (control unit) side. Refer to DESCRIPTION .

    NOTE:

    When U1232 is detected, adjust the predictive course line center position of the steering angle sensor.

    GO TO STEP 2  .

  2. PERFORM DTC CONFIRMATION PROCEDURE AGAIN

    Perform DTC confirmation procedure again. Refer to DTC DESCRIPTION .

    Is DTC U1232 detected again?

    YES 

    Replace steering angle sensor. Refer to REMOVAL AND INSTALLATION .

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals