DTC B2098: Ignition Relay On Stuck: Description

IPDM E/R operates the Ignition Relay when it receives an Ignition Switch ON signal from BCM via CAN Communication.
Turn the Ignition Relay OFF by pressing the Push-Button Ignition Switch once when the vehicle speed is 4 km/h (2.5 MPH) or less.
Turn the Ignition Relay OFF with the following operation when the vehicle speed is more than 4 km/h (2.5 MPH) or when an abnormal condition occurs in CAN Communication from the Unified Meter And A/C Amp. (Emergency OFF)
- Press and hold the Push-Button Ignition Switch for 2 seconds or more.
- Press the Push-Button Ignition Switch 3 times within 1.5 seconds.

NOTE:

The Ignition Relay does not turn ON for 3 seconds after emergency OFF even if the Push-Button Ignition Switch is pressed.