Component Inspection

1. Turn the Ignition Switch OFF.
2. Disconnect the Meter Control Switch connector.
3. Check continuity between the following terminals of the Meter Control Switch.

   Combination Meter			Operation And Status	Continuity
   Connector	Terminal
   M54	6	2	Press (select) switch	Existed
   			Other than the above	Not existed
   	7	2	Press (enter) switch	Existed
   			Other than the above	Not existed
   	3	2	Press (illumination control) switch	Existed
   			Other than the above	Not existed
   	1	2	Press (illumination control) switch	Existed
   			Other than the above	Not existed

Is the inspection result normal?

YES 

INSPECTION END

NO 

Replace the Meter Control Switch.