Diagnosis Procedure

1. Turn Ignition Switch OFF.
2. Disconnect Combination Meter connector and washer level switch connector.
3. Check continuity between Combination Meter Harness Connector and Washer Level Switch Harness Connector.

   Combination Meter		Washer Level Switch		Continuity
   Connector	Terminal	Connector	Terminal
   M53	31	E32	1	Existed

4. Check continuity between Combination Meter Harness Connector and ground.

   Combination Meter		Ground	Continuity
   Connector	Terminal
   M53	31		Not existed

5. Check continuity between Washer Level Switch Harness Connector and ground.

   Washer Level Switch		Ground	Continuity
   Connector	Terminal
   E32	2		Existed

Is the inspection result normal?

YES 

INSPECTION END

NO 

Repair harness or connector.