Diagnosis Procedure

1. Turn Ignition Switch ON.
2. Check the Voltage And Waveform between Combination Meter Harness Connector and ground.

   Terminals			Condition	Voltage And Waveform
   (+)		(-)
   Combination Meter		Ground
   Connector	Terminal
   M53	27		Parking brake applied	Approx. 0 V
   			Parking brake released	Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES 

INSPECTION END

NO 

GO TO STEP 2. 

1. Turn Ignition Switch OFF.
2. Disconnect Combination Meter connector and Parking Brake Switch connector.
3. Check continuity between Combination Meter Harness Connector and Parking Brake Switch Harness Connector.

   Combination Meter		Parking Brake Switch		Continuity
   Connector	Terminal	Connector	Terminal
   M53	27	E107	1	Existed

4. Check continuity between Combination Meter Harness Connector and ground.

   Combination Meter		Ground	Continuity
   Connector	Terminal
   M53	27		Not existed

Is the inspection result normal?

YES 

INSPECTION END

NO 

Repair harness or connector.