Diagnosis Procedure

1. Turn ignition switch ON.
2. Measure voltage between the combination meter harness connector terminals.

   Combination meter			Condition	Voltage (Approx.)
   Connector	Terminal
   	(+)	(-)
   M53	38	16	When trip A/B reset switch is pressed	0 V
   			Other than the above	5 V

Is the inspection result normal?

YES 

INSPECTION END

NO 

GO TO STEP 2. 

1. Turn ignition switch OFF.
2. Disconnect the combination meter and meter control switch connectors.
3. Check continuity between combination meter harness connector and trip A/B reset switch harness connector.

   Combination meter		Trip A/B reset switch		Continuity
   Connector	Terminal	Connector	Terminal
   M53	38	M56	1	Existed
   	16		2

4. Check continuity between combination meter harness connector and ground.

   Combination meter		Ground	Continuity
   Connector	Terminal
   M53	38		Not existed
   	16

Is the inspection result normal?

YES 

INSPECTION END

NO 

Repair harness or connector.