Brake Fluid: Refilling
CAUTION:
- Turn the ignition switch OFF and disconnect the electronic stability program control unit harness connector or the battery negative terminal before performing work.
- Never spill or splash brake fluid on painted surfaces. Brake fluid may seriously damage paint. Wipe it off immediately and wash with water if it gets on a painted surface. For brake component parts, never wash them with water.
- Check that there is no foreign material in the reservoir tank, and refill with new brake fluid.CAUTION:
- Never reuse drained brake fluid.
- Never allow foreign matter (e.g. dust) and oils other than brake fluid to enter the reservoir tank.
- Loosen the bleeder valve, slowly depress the brake pedal to the full stroke, and then release the pedal. Repeat this operation at intervals of 2 or 3 seconds until new brake fluid is discharged. Then close the bleeder valve with the brake pedal depressed. Repeat the same work on each wheel.
- Perform the air bleeding. Refer to BLEEDING BRAKE SYSTEM .