Diagnosis Procedure
- CHECK FUSES
Check if any of the following fuses are blown:
Signal name Fuse No. Battery power supply 90 Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Replace the blown fuse after repairing the affected circuit if a fuse is blown.
- CHECK POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect the side radar LH connector.
- Check voltage between side radar LH harness connector and ground.
Terminals Condition Voltage
(Approx.)(+) (-) Side radar LH Ground Ignition switch Connector Terminal M251 4 OFF 11.0 - 15.5 V Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair the side radar LH power supply circuit.
- CHECK GROUND CIRCUIT
Check continuity between side radar LH harness connectors and ground.
Side radar LH Ground Continuity Connector Terminal M251 1 Existed Is the inspection result normal?
YES
INSPECTION END
NO
Repair the side radar LH ground circuit.